![]() APPLE AirPort Extreme A1408 (MD031LL/A) Hard Reset. Rating: 1.6 - 19 reviews If you found this. Release the button, and AirPort Extreme will reset. If you want to connect to APPLE A1408 for the first time you will need to know the default APPLE A1408 IP address. If your AirPort Extreme has firmware 5.5.1 or later follow these steps:Ĭontinue holding it until you see the center status light (LED) start to flash rapidly, which should happen after about five seconds. ![]() Plug back in the Ethernet cable and reconnect to your network. The base station restarts to load the new settings. Unless you have been given an IP address by your ISP or system administrator, do not change the IP address.Ĭlick Update. Or, turn on encryption (WPA2 is recommended) and enter a new password for your AirPort network. To change the network password, choose the Wireless tab and edit the Wireless password field. To reset base station password, choose Base Station tab and edit the password field. You now have the opportunity to change settings such as base station password, network password, the Access Control List, and RADIUS. Ignore the errors in Base Station Status at this time. Locate and double-click your base station to configure it. Open the Airport Utility from the Applications : Utilities folder. ![]() AirPort will indicate if it's in hard reset mode by blinking faster.įrom the AirPort menu bar item, choose the network created by the base station (the network name does not change). Note: Holding the reset button for 5 seconds or longer will do a hard reset. If you do not make your changes within five minutes of pressing the reset button, the base station will revert to the previous configuration. The base station remains in reset mode for five minutes. The base station password is set to 'public.' The base station name is set to 'base station,' followed by the last six digits of the base station's MAC (Media Access Control) address. Press and hold the base station reset button for one full second. When performing a hard reset or factory-default reset: The base station is set to request an IP address by DHCP. Select Airport from the list of connections on the left. from the Apple menu at the top left hand corner of the screen.Ĭlick the Network icon to open the Network Preferences. The AirPort Extreme must be connected to power during the following steps.ĭisconnect any Ethernet cables from the base station.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |